fitting of the G&P crane stock

again just a simple fitting guide for the crane stock .

Your wire will come out of the hole at the back of the gun as always , note how long the stock tube pipe is if it was any longer your stock would not close fully



now your stock tube and blanking plate , the blanking plate HAS to have a cut out for the wire to pass if it does not it will pinch the wire !!! , also note how the stock tube is made for the wire to pass down



here is a pic of the plate fitted , again note the grove for the wire



now with the stock tube nearly fitted



now these should have come with your stock kit but if you got it second hand off 1 of the forums please note how the main washer ? has a cut out for the wire to pass it


now its just a matter of fitting the stock on the tube ( same as all AR sliders pull the slide catch down as ar as it will go )




all finished , this is a very simple job and should only take 2-3 min max and the only tools you need are a screw driver for the stock bolt