http://airsofthelpinghands.forumotion.net/take-down-guide-s-f33/-t1.htm Wed, 03 Jun 2009 08:02:20 GMT 10 http://illiweb.com/fa/m/logo7.gif http://airsofthelpinghands.forumotion.net/take-down-guide-s-f33/-t1.htm http://airsofthelpinghands.forumotion.net/take-down-guide-s-f33/fitting-of-the-gp-crane-stock-t17.htm johnnyj again just a simple fitting guide for the crane stock . Your wire will come out of the hole at the back of the gun as always , note how long the stock tube pipe is if it was any longer your stock would not close fully now your stock tube and blanking plate , the blanking plate HAS to have a cut out for the wire to pass if it does not it will pinch the wire !!! , also note how the stock tube is made for the wire to pass down here is a pic of the plate fitted , again ... Take down guide's Wed, 03 Jun 2009 08:02:20 GMT http://airsofthelpinghands.forumotion.net/take-down-guide-s-f33/fitting-of-the-gp-crane-stock-t17.htm#22 http://airsofthelpinghands.forumotion.net/take-down-guide-s-f33/fitting-of-the-gp-crane-stock-t17.htm http://airsofthelpinghands.forumotion.net/take-down-guide-s-f33/m4-sliding-stock-take-down-t15.htm johnnyj hi just a simple take down of a m4 sliding stock ( for all bar ics ) First pull the stock catch down away from the stock as far as it will go and slide the stock off the tube : then useing a allen key remove the allen nut and take off the stock tbe end cap then if you look down the stock tube you will see a screw head that goes in to your gearbox remove this " + " driver the stock tube will now slide off the back of your body should ... Take down guide's Sun, 01 Mar 2009 11:38:47 GMT http://airsofthelpinghands.forumotion.net/take-down-guide-s-f33/m4-sliding-stock-take-down-t15.htm#20 http://airsofthelpinghands.forumotion.net/take-down-guide-s-f33/m4-sliding-stock-take-down-t15.htm